Arc drawing
Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.
|
I've been trying to answer the same question, and so far the answer seems to be, "No." I did find this post from Ken Case in the OG mailing list, where he suggests drawing a line, setting the line type to orthogonal, and then adjusting the corner radius until you get the kind of arc you need:
[url]http://www.omnigroup.com/mailman/archive/omnigraffle-users/2005/003607.html[/url] Not sure if this addresses your need for specific degree measurements. |
All times are GMT -8. The time now is 02:35 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.