The Omni Group Forums

The Omni Group Forums (http://forums.omnigroup.com/index.php)
-   OmniGraffle General (http://forums.omnigroup.com/forumdisplay.php?f=10)
-   -   Mix portrait and landscape canvases? (http://forums.omnigroup.com/showthread.php?t=14758)

pooch 2009-12-09 07:31 AM

Mix portrait and landscape canvases?
 
Hi,

I've got a multi-canvas document where all canvases are best shown in Landscape. Now in the middle of them I want to add a canvas that must be Portrait. Googling this, I find in various locations (including on OmniGraffle's web site) the following blurb: "Canvases can be different sizes, and can be rotated 90 when printed, so you can mix landscape and portrait modes."

I don't see how to rotate just one canvas 90 when printing, but even if I did, I would have to lay out my diagram on its side while working in its landscape orientation. So everything I plop down on the canvas would have to be rotated, say 90 counter-clockwise while I was composing the diagram, then at printing time I would have to rotate the canvas 90 clockwise.

Is there an easier way that I'm missing?

Thanks!

Joel 2009-12-09 11:02 AM

You can change orientation for a particular canvas in the Canvas: Size Inspector. Keep in mind that this only changes the dimensions of the canvas itself, and not its printing orientation, which is a document setting.

pooch 2009-12-09 12:18 PM

That does the trick. Thanks Joel.


All times are GMT -8. The time now is 09:13 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.