The Omni Group Forums

The Omni Group Forums (
-   OmniGraffle General (
-   -   Rotating a shape in OmniGraffle (

ekin 2012-02-18 07:51 AM

Rotating a shape in OmniGraffle
Is there any way I can rotate a image at an angle?

whpalmer4 2012-02-18 08:06 AM

1 Attachment(s)
Sure. Select the shape you want to rotate. Bring up the Properties: Geometry inspector. Use the little knob at the upper right to dial in the rotation, or type in a numeric value (in degrees).

You also mentioned rotating an image, which can be done the same way. Draw a shape, bring up the Style: Image inspector, select your image. If you don't want to see the shape you are using as a frame, click on the Style: Lines and Shapes inspector and uncheck the Stroke box.

leetleyang 2012-02-26 10:49 AM

For a quick rotation, you can also hold down the command key then click and drag on a corner/edge point.

john.gersh 2012-02-27 05:14 AM

Another tip:

Once you've clicked on the geometry rotation knob in the inspector or held the command key down in the drawing you can drag the cursor as far away as you''d like from the knob or shape. That can give you a larger radius of rotation, allowing more precise control of the rotation angle.

rotationWheatley 2013-03-21 01:30 AM

In fact, if you take some image rotation sdk, you can rotate your images in any angle.

All times are GMT -8. The time now is 12:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.