Auto-layout adds unwanted mid-points to beziers ?
 

Here is a diagram from which all Bezier mid-points have been removed.

If Automatic layout is applied, some of the connectors mysteriously acquire unrequested mid-points, conferring an unwelcome misalignment.

The spurious mid-points can be deleted (and the lines restored to health) by selecting the affected lines, and using [B]Inspectors > Lines & Shapes > Remove MidPoints[/B].

Unfortunately, repeating Automatic Layout will put the unwanted mid-points back, and reimpose the unexpectedly eccentric look ...

BEFORE automatic layout:

[IMG]http://forums.omnigroup.com/attachment.php?attachmentid=2210&stc=1&d=1325873708[/IMG]

AFTER automatic layout:

[IMG]http://forums.omnigroup.com/attachment.php?attachmentid=2209&stc=1&d=1325873708[/IMG]