The Omni Group Forums

The Omni Group Forums (
-   OmniGraffle General (
-   -   tangential connectors (

timcoote 2010-02-25 08:30 AM

tangential connectors
I'm trying to draw a 'blow up' of a part of a drawing by putting a circle around the area in the original drawing, with a larger circle showing the detail off to the side. I'd like to draw a couple of connectors that are tangential to the two circles (and stop on the edge of each). Is there an easy way to do this or do I have to add magnets to each and then manually move them if I move the circles relative to each other?


All times are GMT -8. The time now is 04:36 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.