The Omni Group Forums

The Omni Group Forums (
-   OmniGraffle General (
-   -   Not quite getting orthogonal lines... (

bheller 2013-05-20 09:18 PM

Not quite getting orthogonal lines...
1 Attachment(s)
These seem to work fairly slick much of the time, but I'm also stumped by some behavior:
If I have an orthogonal lines (as shown in the attachment) and I move the lower horizontal segment up/down, it ALSO moves the other upper one. I want to move them *independently*, so I can put the orthogonal angles where I want them.

Check the forum and manual, so maybe there's something about this I'm not understanding...?


bheller 2013-05-25 08:46 AM

Any ideas here? Seems I'm missing something pretty basic...

steve_s 2013-06-03 05:05 PM

Hi bheller! Try double-clicking on the segment below to add a point. Then select that point and drag it around. Hope that helps!

All times are GMT -8. The time now is 06:52 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.