Easy way to make line junctions "hop" over/under?
 

Hi folks,

I am doing a wiring diagram.

Normally, when drawing by hand, where one wire passes over another wire there is a little curved hop in the uppermost wire to make it clear which wire is which. Without this there is no easy way to tell what is happening with the wires at the point of cross-over. Do they join? Which one goes where? Etc. With the little curved "hop" or bridge (not sure what to call it) it is very clear that each wire is separate and which one goes where.

Is there an easy way to do this in OG?

Hi again! You can make a line "hop" by selecting the line and adjusting the "Line Hops" property in the Lines and Shapes tab of the Style inspector. Hope that helps!

[QUOTE=steve_s;124238]Hi again! You can make a line "hop" by selecting the line and adjusting the "Line Hops" property in the Lines and Shapes tab of the Style inspector. Hope that helps![/QUOTE]

Beautiful. Thanks Steve. That's exactly the feature I was hoping I'd failed to see. Perfect!