The Omni Group Forums

The Omni Group Forums (http://forums.omnigroup.com/index.php)
-   OmniGraffle General (http://forums.omnigroup.com/forumdisplay.php?f=10)
-   -   Angular dimensioning (http://forums.omnigroup.com/showthread.php?t=11395)

warrenn 2009-02-22 05:01 PM

Angular dimensioning
 
I have a drawing with two intersecting lines and I need to display the angle between the lines. The usual practice is to have an arc whose center is at the intersection with arrowheads on each end touching the lines. I tried this in OG and quickly found that arcs are shapes, not a line variant (not surprising since the arc is found in the shapes stencil). Therefore, arrowheads are not easily attached and - most importantly - the endpoints of the arc (with magnets) don't snap to the lines. Is there an easy work-around?

Thanks.

Warren Nagourney


All times are GMT -8. The time now is 01:33 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.