The Omni Group Forums

The Omni Group Forums (http://forums.omnigroup.com/index.php)
-   OmniGraffle General (http://forums.omnigroup.com/forumdisplay.php?f=10)
-   -   Arc drawing (http://forums.omnigroup.com/showthread.php?t=363)

danaspiegel 2006-05-04 02:06 AM

Arc drawing
 
Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.

B. Schmidt 2006-05-04 03:30 AM

I've been trying to answer the same question, and so far the answer seems to be, "No." I did find this post from Ken Case in the OG mailing list, where he suggests drawing a line, setting the line type to orthogonal, and then adjusting the corner radius until you get the kind of arc you need:

[url]http://www.omnigroup.com/mailman/archive/omnigraffle-users/2005/003607.html[/url]

Not sure if this addresses your need for specific degree measurements.


All times are GMT -8. The time now is 06:54 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.