Not quite getting orthogonal lines...
1 Attachment(s)
Hi,
These seem to work fairly slick much of the time, but I'm also stumped by some behavior: If I have an orthogonal lines (as shown in the attachment) and I move the lower horizontal segment up/down, it ALSO moves the other upper one. I want to move them *independently*, so I can put the orthogonal angles where I want them. Check the forum and manual, so maybe there's something about this I'm not understanding...? Thanks, brian |
Any ideas here? Seems I'm missing something pretty basic...
|
Hi bheller! Try double-clicking on the segment below to add a point. Then select that point and drag it around. Hope that helps!
|
All times are GMT -8. The time now is 05:44 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.