The Omni Group Forums

The Omni Group Forums (http://forums.omnigroup.com/index.php)
-   OmniOutliner 3 for Mac (http://forums.omnigroup.com/forumdisplay.php?f=9)
-   -   Freaking out with single-column page setup (http://forums.omnigroup.com/showthread.php?t=2366)

abh19 2006-12-08 02:40 PM

Freaking out with single-column page setup
 
Hi there,

I'm using OOP 3.6.1v143.15 on a macbook C2D.

I think this is a bug, but it might be my machine... When I select a single column to print in the page setup dialog, I get problems if that column is not the outline column. When I go back to the "general" tab, I'm stuck there and I can't get back to the columns to change it back (until I restart the program). In addition, it freaks out when I go to save the document (I get a blank space where the save/print dialog should be). I can save it, I just can't see all the buttons or navigate to save as a different name/different location.

I would like to have the ability to print a single column (that's not the ouline column). Is this a bug or is my computer doing something unusual?

Thanks!


All times are GMT -8. The time now is 01:29 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.