The Omni Group Forums

The Omni Group Forums (
-   OmniGraffle General (
-   -   Line ending bug in layers (

enderw88 2011-10-16 09:32 AM

Line ending bug in layers
3 Attachment(s)
I apologize if this has been reported before, but I couldn't find mention of it.

I am trying to produce a wiring diagram. The wires are color coded with a base color and a stripe. Since there appears to be no way to control the internal color of a double stroked line, I opted to put the base color on one layer then layout an identical line over it with the strip color. I use 6pt ortho line on the base layer, and 2 point ortho line on the strip layer. Aside from the extra effort, it work fine except at the line ends.

When I put a stripe line over the base line the base line is not drawn all the way to the component.

If I shift the end point of the stripe line over one magnet, then the base line is drawn correctly.

I have attached PNGs of the problem, as well as a demo graffle file.

Is there a work around?

I have found one work around: draw the line in the opposite direction. The strip line is drawn in the opposite sense form the base line, then the gap doesn't appear.

john.gersh 2011-10-17 05:32 AM

Looks like a pretty bad bug. It gets even worse if you put an arrowhead on upper end of the black line. I'd report it as one to OG; use the Send Feedback item in the Help menu.

All times are GMT -8. The time now is 10:22 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.