The Omni Group Forums

The Omni Group Forums (
-   OmniGraffle General (
-   -   Arc drawing (

danaspiegel 2006-05-04 03:06 AM

Arc drawing
Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.

B. Schmidt 2006-05-04 04:30 AM

I've been trying to answer the same question, and so far the answer seems to be, "No." I did find this post from Ken Case in the OG mailing list, where he suggests drawing a line, setting the line type to orthogonal, and then adjusting the corner radius until you get the kind of arc you need:


Not sure if this addresses your need for specific degree measurements.

All times are GMT -8. The time now is 07:35 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.