The Omni Group Forums

The Omni Group Forums (http://forums.omnigroup.com/index.php)
-   OmniGraffle General (http://forums.omnigroup.com/forumdisplay.php?f=10)
-   -   Orthogonal Line Connectors (http://forums.omnigroup.com/showthread.php?t=11621)

Sophie 2009-03-14 02:03 PM

Orthogonal Line Connectors
 
How can I force an orthogonal line to run from the bottom edge of rectangle 1 to the left edge of rectangle 2? On a 3-section orthogonal line (vertical-horontal-vertical : I can only grab the horizontal segment and move it up/down). Can I also move the end points or 2 end segments?

Joel 2009-03-14 02:19 PM

You can put some magnets on your shapes using the Magnet Tool or the Connections Inspector and the line should snap nicely to the magnets.

Sophie 2009-03-14 03:36 PM

Thanks, that works brilliantly !


All times are GMT -8. The time now is 03:12 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.