[repalermo]

I recently did a floor plan layout at a ruler scale of 1 in = 1 ft. The scaling worked great; objects were easily dimensioned using the Inspector to the macro scale, and the printouts were all true to scale.

I then needed to make the same drawing at a scale of 1/2 in = 1 ft.

Simply printing at 50% reduction did not provide a drawing true to that scale.

I also tried to edit the ruler scale to this 0.5 in = 1 ft. This appeared to give the proper transformation of the diagram. The diagram went from spanning multiple pages down to just printing on one sheet. However the printout was not true to scale, and appeared to be at about 110% of the desired.

Can anyone instruct me on the proper way to accomplish this?