View Single Post
Thanks again.

I figured out how to install and use the script, but it's very much hit and miss.
The thing is that I have no idea which pixel values to enter, so it's all a matter of guessing. Is there a way to read the current width, then make some minor adjustments according to that?

I've already taken care to adjust the who table width until I see a couple of red "Page boundary" show up. Aligning this is pretty hard, and doesn't seem to be pixel accurate, which means that I certainly won't be getting the same width for all my documents.
What's the best way to go about this?

Last edited by technica; 2008-02-12 at 10:42 PM..