[stephens]

Hi,
I just finished 6 sheets of diagrams for a project I'm working on (I was going to import it into Word 2007 from Visio 2007).

It's fairly simple stuff...only lines and boxes and text.

After goofing around in Visio 2007 with the drawing to see what the heck was going on, I discovered that you guys are exporting lines as right-angle connectors!! The drawing looks fine in Visio --- that is --- until you try to move any diagonal line... that really shows the mistake.

I found this out the hard was when I imported the Visio sheets using copy/paste into Word 2007. BAM. All the lines went screwy as they immediately attempted to reconnect themselves as right-angles (especially all the lines that were running diagonal!).

PLEEEEEEEZE fix this. I had to run through all my drawings changing the line types in Visio 2007. It took me several hours.
-ron