View Single Post
I've just started using OmniGraffle and so far, things are going well. However, I've encountered two problems that I don't understand.

I am currently building up a stencil library. I need everything to be on a fixed grid, so snap-to-grid is always on. My major grid is 1cm with 10 divisions (ie. minor grid is 1mm) The alignment guides are off.

First, I'm having trouble attaching magnets to on-grid points. Sometimes, it works. Other times, it's snapping to one of the (supposedly off) guides. I have the most trouble with triangles. I've included a picture. I can't get a magnet to the point shown in the picture. I have been able to hand place it, but never accurately. Notice that one of the "okay" magnet points is actually off-grid.

The second thing I've encountered is a strange behavior when things are grouped. I've drawn and grouped the same figure, once "upward" and once "downward" (See attached). Notice that the blue bounding box in the upward file does not land on the grid, while the one for the downward one does. After grouping the downward one, I can rotate/flip it to look just like the other, except that now, the bounding box is correct. Since I need everything on-grid, I ended using the downward file.... but what is going on here?

Kevin
Attached Thumbnails
Click image for larger version

Name:	magnet.jpg
Views:	344
Size:	15.6 KB
ID:	991   Click image for larger version

Name:	up.jpg
Views:	308
Size:	15.3 KB
ID:	992   Click image for larger version

Name:	down.jpg
Views:	302
Size:	14.3 KB
ID:	993