[kenny]

I just upgraded to OmniGraffle 5 Pro and it does contain quite a few features that are most valuable for my job - especially the presentation mode is a real time saver!

However, I happen to work with a lot of complex process diagrams which I will store in sub-diagrams and it would be great if I could just "click-open" them in presentation mode instead of having to prepare different pages.

I could then show a process overview and "tear open" relevant sub-diagrams which would open "in place". I hope I am expressing myself clearly enough here :)

Maybe it´s already there and I haven´t seen it yet but if it isn´t there, this would be a great thing to have.

Kenny