Guest
2012-03-28, 07:35 AM
72dpi is the default for screens.
If you have:
- used the Canvas inspector to set Canvas > Size > Ruler Units to pixels,
- used the Properties > Geometry inspector to give the shape a height and width of 100px each,
You should get a pixel-proportionate export using the settings shown here:
Note that current selection export frames the shape with a bit of margin even if you uncheck 'include margin', but you can shave this down by giving a negative margin value.
I am getting a closely cropped 101 pixels square PNG from the above from an OG circle sized at 100px height and width - about right because its stroke is not zero width ...
--
--
Last edited by RobTrew; 2012-03-28 at 07:44 AM..