[Santa Cruz Jimbo]

I'm doing a floor plan, and have several room rectangles and several connecting door rectangles that overlap from room to room.

I can "union" the rooms together until they reach a certain size, then the union stops working.

You can repeat it by doing this...

On a virgin single page canvas, draw a rectangle that stretches from the left side of the page to the right side.

Draw another on from the top to the bottom. You've just made a big cross.

Select both rectangles and perform an "Edit->Shapes->Union" command. You *should* get a nice cross shape with no overlaping lines. But you dont.

Make the rectangles smaller, about half the page size, and try again. Then it works.

Is it just me?

-Jimbo