View Single Post
Thanks for the quick reply, and for the suggestion!

That did indeed work me, although it was mighty tedious. A quicker way to do this would sure be nice, because it's something I need to do quite often.

The application is drawing bus wires in electronic schematics. At the start of the process, I draw full-length lines, since I don't know how much room I'll need until later. Once the schematic is done, I want to shorten all the bus lines to clean things up, but now there are (potentially) dozens of things connected to the line.

If there was a way to shorten the line, or subdivide and delete a section of it, that would be ideal. Thanks again for the suggestion, though! It got me through this time.