Hello All,
I'm looking to for explicit control of the plunge of my curve between two points, as I'm accustomed to with bezier curves ( see hteeteepee: upload.wikimedia.org/wikipedia/en/b/b8/Bézier_curve_in_Adobe_Illustrator_CS2.png).
How can I do this in OmniGraphSketcher?
Thanks,
Jason
PS: See attached for the curve I'm trying to create. (with overlay source shown)
I'm looking to for explicit control of the plunge of my curve between two points, as I'm accustomed to with bezier curves ( see hteeteepee: upload.wikimedia.org/wikipedia/en/b/b8/Bézier_curve_in_Adobe_Illustrator_CS2.png).
How can I do this in OmniGraphSketcher?
Thanks,
Jason
PS: See attached for the curve I'm trying to create. (with overlay source shown)