The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Newbie: Lines with arrowheads on both ends Thread Tools Search this Thread Display Modes
I feel most dumb, but I see no way to do it. Pls point me in the right direction, I need to create bidirectional lines.


With the line selected, open the Lines and Shapes inspector. To change the line endings and line style, use the menus in the red box below:

As another newb, this was something that initially stumped me as well.

Just to add to the response above, instead of trying to add two arrow heads to a single line, i've found it easier to start with a single arrow-headed line and then use the pull-down menu to add an arrow head to the other end.

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
double headed arrows/line with two arrowheads richardswancott OmniGraffle General 1 2012-08-22 12:14 AM
Mitering line ends lsamberg OmniGraffle General 4 2012-07-27 04:42 AM
Arrowheads at each directional change with lines Kitesurfa OmniGraffle General 1 2012-05-11 03:55 AM
Manipulating Arrowheads PMulvey OmniGraffle General 1 2011-08-03 10:25 AM
Creating new line ends jack_cox OmniGraffle Extras 3 2007-12-17 12:31 PM

All times are GMT -8. The time now is 09:36 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.