Hello.
If I select a lot of tasks, even within task groups, and press the space bar, they all get checked-off (as expected).
But if I then try to reverse the procedure and press the space bar again, ONLY tasks outside of task groups get unchecked. If I want to uncheck the tasks inside the task groups, I must select them and press the shortcut again... boring.
Also, if I check a parent task by clicking on its checkbox, its children get checked, as expected. But the opposite is not true either...
This is a little frustrating because I just finished setting up a few check lists and checking/unchecking tasks like this becomes tedious after a while.
Is this behavior on purpose or should I report this "inconsistency" to the Ninjas?
If I select a lot of tasks, even within task groups, and press the space bar, they all get checked-off (as expected).
But if I then try to reverse the procedure and press the space bar again, ONLY tasks outside of task groups get unchecked. If I want to uncheck the tasks inside the task groups, I must select them and press the shortcut again... boring.
Also, if I check a parent task by clicking on its checkbox, its children get checked, as expected. But the opposite is not true either...
This is a little frustrating because I just finished setting up a few check lists and checking/unchecking tasks like this becomes tedious after a while.
Is this behavior on purpose or should I report this "inconsistency" to the Ninjas?