 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
| FAQ | Members List | Calendar | Today's Posts | Search |
| Multiple Lines Connecting Objects | Thread Tools | Search this Thread | Display Modes |
|
Member
2010-01-25, 11:56 AM
When multiple lines connect between two objects and "Layout Entire Canvas" is selected the lines end up on top of each other.
Is there any way to make sure that lines between the same two objects do not cover each other up?
Post 1
|
|
Omni
2010-01-25, 01:26 PM
You can put some magnets on your shapes using either the Magnet Tool or the Connections Inspector, and then connect the lines directly to the magnets as opposed to simply snapping to the nearest one, that should work.
Hope that helps,
__________________
"Vroom! Vroom!!"
Post 2
|
|
Member
2010-01-25, 02:55 PM
Thanks, I'll try that.
Post 3
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Objects moving around when connecting them with lines | Imme2011 | OmniGraffle General | 2 | 2012-04-11 08:04 AM |
| Questions about lines connecting objects | MrSmith | OmniGraffle General | 1 | 2011-09-06 06:38 AM |
| Connecting objects between shared layers | drzow | OmniGraffle General | 2 | 2009-09-03 07:40 AM |
| Connecting lines? | fridge | OmniGraffle General | 3 | 2008-08-25 10:11 AM |
| Connecting lines | areiser | OmniGraffle General | 0 | 2006-07-27 07:47 AM |
Linear Mode
