Hi there,
I'm using OOP 3.6.1v143.15 on a macbook C2D.
I think this is a bug, but it might be my machine... When I select a single column to print in the page setup dialog, I get problems if that column is not the outline column. When I go back to the "general" tab, I'm stuck there and I can't get back to the columns to change it back (until I restart the program). In addition, it freaks out when I go to save the document (I get a blank space where the save/print dialog should be). I can save it, I just can't see all the buttons or navigate to save as a different name/different location.
I would like to have the ability to print a single column (that's not the ouline column). Is this a bug or is my computer doing something unusual?
Thanks!
I'm using OOP 3.6.1v143.15 on a macbook C2D.
I think this is a bug, but it might be my machine... When I select a single column to print in the page setup dialog, I get problems if that column is not the outline column. When I go back to the "general" tab, I'm stuck there and I can't get back to the columns to change it back (until I restart the program). In addition, it freaks out when I go to save the document (I get a blank space where the save/print dialog should be). I can save it, I just can't see all the buttons or navigate to save as a different name/different location.
I would like to have the ability to print a single column (that's not the ouline column). Is this a bug or is my computer doing something unusual?
Thanks!