The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniWeb > OmniWeb General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Setting tabs to snapshot upon start Thread Tools Search this Thread Display Modes
OK, I know this is dumb question but I cant figure it out. Before upgrading to 5.9.x I set my preferences to pull up four tabs (set as a snapshot) when OW started. Now when OW starts it pulls up the same tabbed windows I had open before closing. How can I change it back to the way it was (with 4 specific tabs opening)? Thanks and sorry to be such a numbskull. Mike
Uncheck the Auto-save while browsing radio button in the Workspace's window:

With it checked (as in the image above), OmniWeb will remember the state of your Workspace when you quit and then re-open all the tabs when you next launch it. If it isn't checked, it will either open a default tab or the tabs stored in the snapshot for that Workspace if you have taken one.
That worked like a CHARM, thanks so much Jonathon! Mike

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Perspective Snapshot Goes Gray after Adding "Start Date" Revearti OmniFocus 1 for Mac 2 2013-02-06 01:30 PM
Stopping the start page from opening in new tabs mrpicadilly OmniWeb General 1 2009-04-13 12:45 PM
setting Start and Due Dates muddling OmniFocus for iPhone 2 2008-08-25 11:39 AM
Workspaces: Restore Snapshot On Start? Shifting Sands OmniWeb General 1 2007-07-17 11:10 AM
Setting Start Page 996tt OmniWeb General 2 2006-07-28 02:06 PM

All times are GMT -8. The time now is 12:09 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.