The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Circular automatic layout is spreading out too far Thread Tools Search this Thread Display Modes
I'm trying to use the circular automatic layout style but it's spreading my objects out in weird and wonderful ways, basically sending them miles away. I've tried to reduce the line length with no success. I've attached a link to a screenshot of the problem (it's a large image).

Any ideas what's going on?

Thanks,
Rob.
 
In quick testing this doesn't appear to be happening on my end, however if you could send your file in to omnigraffle@omnigroup.com we'd like to take a look at it.
__________________
"Vroom! Vroom!!"
 
Hi there,

I'd just like to point out that I'm also experiencing this problem.

It's making using Omnigraffle 5 for brainstorming a challenge right now - Omnigraffle 4 seemed to handle this situation better.

Cheers,
James
 
If you're seeing this, please send your document to the address in Joel's post. Thanks!
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Can I undo automatic layout? gozulin OmniGraffle General 5 2012-07-18 04:26 PM
Automatic layout difficulties silverpie OmniGraffle General 1 2010-10-01 03:18 PM
Automatic Layout with Automatic Re-alignment michael.prescott OmniGraffle General 0 2010-03-10 06:27 AM
Automatic Layout is Square philipt18 OmniGraffle General 0 2009-02-19 07:43 AM
automatic layout problem markb OmniGraffle General 1 2008-04-12 02:48 PM


All times are GMT -8. The time now is 02:31 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.