The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Diagonal line over rectangle Thread Tools Search this Thread Display Modes
Hi,
I'd like to draw a diagonal line over a rectangular shape. I've tried putting magnets in the corners and drawing a line between two of them, but the line, although it exists in the List, isn't displayed in the diagram.
Any ideas?
Many thanks,
Guy.
 
Since the line is attempting to connect the same shape to itself, I'd draw the line separately first, set it to not connect to any shapes in the Connections Inspector, and then position it the way you'd like.

Hope that helps,
__________________
"Vroom! Vroom!!"
 
Thanks Joel, that solves my problem.
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
1-Line Item Display (small checkboxes) vs. 2-Line Item Display (large checkboxes) bafranklin OmniFocus 2 for Mac (Private Test) 5 2013-04-20 02:33 AM
Round line ends not centered on end of line billbrietstout OmniGraffle General 3 2012-05-17 08:08 AM
Select only object that are entirely inside the selection rectangle bartzumbari OmniGraffle General 1 2012-04-04 11:21 AM
Action inspector > jumps elsewhere > zooms to display a rectangle NOT WORKING! free3moose OmniGraffle General 0 2010-11-10 01:29 AM
Re-size rectangle to minimum size around text jem OmniGraffle General 3 2007-11-26 12:27 PM


All times are GMT -8. The time now is 10:47 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.