 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
| FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| How to stop a line snapping to object in Omnigraffle? | Thread Tools | Search this Thread | Display Modes |
|
Member
2013-03-03, 06:17 PM
I have battled with this for hours, googled my head off and can't find the answer. I just want to draw a line from one place to another, and not have it snap to a connector point on an object. Then I want to rotate it.
Post 1
|
|
Member
2013-03-03, 08:26 PM
Try holding down the option key while drawing the line.
Post 2
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to stop a line snapping to object in Omnigraffle? | lukesawyer | OmniGraffle General | 3 | 2011-12-22 09:13 AM |
| Stretching and snapping to object edge | jmca | OmniGraffle General | 0 | 2011-12-06 06:36 AM |
| Can't detach a line from an object | countdrachma | OmniGraffle General | 2 | 2011-08-16 08:21 PM |
| How to stop a line snapping to object in Omnigraffle? | ardyayaf | OmniGraffle General | 2 | 2011-03-02 09:47 AM |
| How to turn off line "snapping"? | technica | OmniGraffle General | 4 | 2008-01-29 06:14 PM |
Linear Mode
