The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Shape Union Bug? Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
I'm doing a floor plan, and have several room rectangles and several connecting door rectangles that overlap from room to room.

I can "union" the rooms together until they reach a certain size, then the union stops working.

You can repeat it by doing this...

On a virgin single page canvas, draw a rectangle that stretches from the left side of the page to the right side.

Draw another on from the top to the bottom. You've just made a big cross.

Select both rectangles and perform an "Edit->Shapes->Union" command. You *should* get a nice cross shape with no overlaping lines. But you dont.

Make the rectangles smaller, about half the page size, and try again. Then it works.

Is it just me?

-Jimbo
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
How to change a shape jerry92 OmniGraffle General 3 2009-05-11 01:50 AM
annotation shape jj91709 OmniGraffle Extras 1 2009-03-18 06:11 PM
How to name a shape? markacruciani OmniGraffle General 2 2008-06-25 05:55 PM
How about a general state of the union address on OF at this point in time? dude OmniFocus 1 for Mac 30 2007-12-05 07:46 AM
oregon community credit union and omniweb/safari dougclark OmniWeb General 3 2006-12-08 02:36 PM


All times are GMT -8. The time now is 04:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2023, vBulletin Solutions, Inc.