The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Cannot save - "Cross-reference table doesn't end correctly"? Thread Tools Search this Thread Display Modes
This is repeatable. I just installed the following version:
Product: OmniGrafflePro-5.1
Tag: OmniGraffle/5.1.1/final-137.11

I just need to create a blank document and try to save it to get the following message:
The document “Untitled” could not be saved as “test”. Cross-reference table doesn't end correctly.

Anyone knows how to fix this?

I'm having the same problem!!!!
I am using OmniGraffle/5.2/final-138.9 and having the same problem. It does not allow me to save any file. Any work around to this problem?
I'm not on the OmniGraffle team, so I don't know exactly what's going on here. If you email the support ninjas, though, you're guaranteed a response from someone more knowledgeable than I. :-)

Folks here browse the forums as we're able, but it's on an "as we can" basis, so I wanted to make sure this didn't wait too long.
Inspectors -> Document: Uncheck "Include Quick Look Preview"
Saving should work.

For me, this is checked for every new document I create.
I was in the same position... And I don't know how to overcome Hillhurst Sunnyside it. Any ideas?

Last edited by Afro-head1; 2013-05-14 at 07:22 PM..
Sorry for the trouble, Yava! Can you email details of the issue to Our support folks will be happy to investigate this with you.

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Bug? Group cannot "Make table" jdmuys OmniGraffle General 3 2012-02-14 04:50 AM
"Unable to Save Change" When Checking of Item monooso OmniFocus 1 for Mac 3 2011-09-23 08:12 AM
"Utility" drawer still doesn't restore correctly after hiding styles Stormchild OmniOutliner 3 for Mac 1 2009-06-30 12:22 PM

All times are GMT -8. The time now is 12:32 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.