Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
Guest
2006-05-04, 03:06 AM
Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.
Post 1
|
Guest
2006-05-04, 04:30 AM
I've been trying to answer the same question, and so far the answer seems to be, "No." I did find this post from Ken Case in the OG mailing list, where he suggests drawing a line, setting the line type to orthogonal, and then adjusting the corner radius until you get the kind of arc you need:
http://www.omnigroup.com/mailman/arc...05/003607.html Not sure if this addresses your need for specific degree measurements.
Post 2
|
Thread Tools | Search this Thread |
Display Modes | |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drawing splines? | dave256 | OmniGraffle for iPad | 5 | 2012-04-17 01:46 PM |
Drawing Parabolas | ajrose | OmniGraffle General | 5 | 2011-11-11 12:31 AM |
No drawing size? | billbrietstout | OmniGraffle General | 3 | 2010-06-18 12:29 PM |
need help drawing an arc | amritsari | OmniGraffle General | 0 | 2008-01-24 05:20 PM |
drawing bugs | nivenh | OmniWeb General | 2 | 2006-07-20 05:21 PM |