 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
| FAQ | Members List | Calendar | Today's Posts | Search |
| problem saving | Thread Tools | Search this Thread | Display Modes |
|
|
|
Member
2009-12-10, 10:44 AM
Hi,
After I import a figure into omnigraffle, I am unable to save my document. When I do file -> save, I get the error message "Print: Error While Printing" Do you know what is going on? Thanks, Andrew
Post 1
|
|
Member
2010-02-04, 04:33 PM
I'm having the same problem. Sometimes my stencils dissapear as well. The two problems seem to be ralated.
Post 2
|
|
Member
2010-02-09, 10:25 AM
Bump...
Any help on this? Here is a screen-shot. Last edited by bryanerank; 2010-02-09 at 10:28 AM..
Post 3
|
|
Omni
2010-02-09, 10:30 AM
Try turning off the Quick Look preview in the Document Inspector, that *should* alleviate the problem.
Hope that helps,
__________________
"Vroom! Vroom!!"
Post 4
|
|
Member
2010-02-09, 10:48 AM
Dat worked!
Thanks very much, it was really bugging me.
Post 5
|
|
Member
2009-12-13, 08:09 AM
Try the Evrsoft forums and support? I'm not sure an existing thread about an issue with a diagramming tool that only runs on Mac OS X would be the obvious first place to seek help with a Windows HTML editor :-)
Post 6
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem saving in Omnigraffle 5.0 | bashiri | OmniGraffle General | 7 | 2012-01-31 02:29 PM |
| Problem With Saving Tasks | Lnaccarato | OmniFocus 1 for Mac | 2 | 2011-01-17 07:03 AM |
| Saving as a PDF | namchampa | OmniGraffle General | 2 | 2009-01-18 12:37 AM |
| Saving as pdf | ferreiralady | OmniOutliner 3 for Mac | 2 | 2007-03-03 03:16 PM |
| Problem saving file | Forrest | OmniWeb Bug Reports | 0 | 2006-05-29 10:37 AM |
Hybrid Mode