The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle for iPad
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
How to edit/draw bezier connectors? Thread Tools Search this Thread Display Modes
Hi all,

can anybody tell me how to convert a connector line I've drawn to bezier? Inserting a bspline point works by double tapping. No luck with bezier though. If I create a bezier connector stencil the handles are there, but then the connector always points to the nodes center instead of its rim.

Thanx for your help in advance,

best mnu
 
I share the same need
 
Quote:
Originally Posted by mnu View Post
Hi all,

Inserting a bspline point works by double tapping.
I'm assuming you need more than just adding points on the line & playing with the radius of curvature in the inspector?
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Crooked connectors CVN OmniGraffle for iPad 7 2013-03-26 01:02 AM
Help With Line Connectors... Marty_Rush OmniGraffle General 0 2013-01-19 07:19 PM
connectors mess synthview OmniGraffle General 0 2011-09-07 06:17 AM
tangential connectors timcoote OmniGraffle General 0 2010-02-25 07:30 AM
Connectors Problem gigamike OmniGraffle General 1 2006-08-01 11:10 PM


All times are GMT -8. The time now is 11:04 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.