 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
Member
2008-12-18, 05:33 AM
Why is it that when I set up a page to be 11 x 17" (legal) the actual page dimensions are less than that.
See the pic.  Am I missing a setting somewhere? Last edited by powers; 2008-12-18 at 05:36 AM..
Post 1
|
|
Omni
2008-12-18, 10:04 AM
We typically don't show the non-printable margin areas, which accounts for the canvas being smaller than the page setup size, you can zero out the margins in the Document Inspector if you like.
__________________
"Vroom! Vroom!!"
Post 2
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| different page-setup for each canvas | MatthewS | OmniGraffle General | 3 | 2012-05-16 09:08 AM |
| Change Page Setup params through AppleScript GUI Scripting for OmniGraffle 5 | coswald007 | AppleScripting Omni Apps | 1 | 2011-10-13 04:43 AM |
| Don't see Page Setup Dialog box | PaulFoglia | OmniPlan General | 6 | 2008-10-17 02:02 PM |
| [OG4] Document does not remember page setup/printer settings | Christian Roth | OmniGraffle General | 1 | 2008-05-05 02:33 PM |
| Freaking out with single-column page setup | abh19 | OmniOutliner 3 for Mac | 0 | 2006-12-08 02:40 PM |
Linear Mode
