I've looked all around on the internets, have asked friends, and have spent hours on this. I cannot figure it out.
I've created an OmniGraffle document with a box that extends from the left-most edge of the page to about an inch from the other side. When I print using the Canon iP1800 driver on my system the box mentioned above gets cut off on the left size of the page. This printer driver has a "Borderless" option and even when "Amount of Extension" is set to Max the border appears in the preview window (see attached image). This happens even when I choose "US Letter (Borderless)" as paper size.
Thinking this problem was specific to this printer I've installing CUPS-PDF and used a number of different drivers but I get the same results-- the PDF always shows with the borders cutting off the image. I've even created a custom borderless paper size but no luck there either.
Any idea what I need to do to print a borderless PDF of my OmniGraffle document? I never imagined this would be so difficult. I'm using OmniGraffle 5.1.1 on OS X 10.5.8 (Leopard).
Thanks in advance for your help.
I've created an OmniGraffle document with a box that extends from the left-most edge of the page to about an inch from the other side. When I print using the Canon iP1800 driver on my system the box mentioned above gets cut off on the left size of the page. This printer driver has a "Borderless" option and even when "Amount of Extension" is set to Max the border appears in the preview window (see attached image). This happens even when I choose "US Letter (Borderless)" as paper size.
Thinking this problem was specific to this printer I've installing CUPS-PDF and used a number of different drivers but I get the same results-- the PDF always shows with the borders cutting off the image. I've even created a custom borderless paper size but no luck there either.
Any idea what I need to do to print a borderless PDF of my OmniGraffle document? I never imagined this would be so difficult. I'm using OmniGraffle 5.1.1 on OS X 10.5.8 (Leopard).
Thanks in advance for your help.
Last edited by 3030vision; 2009-08-26 at 12:07 AM..