How to edit/draw bezier connectors? - The Omni Group Forums

These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

mnu

Member

2010-06-13, 09:32 AM

Hi all,

can anybody tell me how to convert a connector line I've drawn to bezier? Inserting a bspline point works by double tapping. No luck with bezier though. If I create a bezier connector stencil the handles are there, but then the connector always points to the nodes center instead of its rim.

Thanx for your help in advance,

best mnu

Post 1

« Previous Thread | Next Thread »

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Crooked connectors	CVN	OmniGraffle for iPad	7	2013-03-26 01:02 AM
Help With Line Connectors...	Marty_Rush	OmniGraffle General	0	2013-01-19 07:19 PM
connectors mess	synthview	OmniGraffle General	0	2011-09-07 06:17 AM
tangential connectors	timcoote	OmniGraffle General	0	2010-02-25 07:30 AM
Connectors Problem	gigamike	OmniGraffle General	1	2006-08-01 11:10 PM

All times are GMT -8. The time now is 03:14 AM.