The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniPlan > OmniPlan General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Problem with export to Microsoft Project Thread Tools Search this Thread Display Modes
I have exported an Omniplan file to MS Project (using the XML option) and imported it into Project 2007. It displays fine, and the columns show the correct dependencies. However, when my client moves a task to the right, an error message is shown to say that the action will cause a scheduling conflict, whereas, based on the settings, dependent tasks should move to the right - as they do in the Omniplan file.

A couple of hours investigation has shown that none of the tasks exported from Omniplan behave properly in MS Project - changing constraint type has no effect, and they do not move around via dependencies.

I have compared all the settings for a new task entered in Project, that behaves normally, with ones imported from OmniPlan and can see no differences. To rule out a problem with my file, I created a new one with only three dependent tasks; exactly the same problems occurred. I have also tested on two different Macs (Omniplan) and PCs (MS Project), and tried both the Project XML and MPX export options.

I detest Project as much as everyone else, and love Omniplan, but my client uses it and insists on receiving files in Project. Any help will be gratefully received. The Omniplan, XML and MS Project files are attached for the three task test in case that is helpful.
Attached Files
File Type: zip (62.8 KB, 1233 views)
Wish I could help more directly, but I don't have Project, and that seems like an essential component for this problem!

You should send those files and a copy of your posting to the support ninjas at -- they only read the forums on an as-available basis, and I don't think any of the OmniPlan gang read the OmniGraffle forum, where you posted this :-)
Very many thanks for your advice - I have emailed the address you suggested and hope they can help :)

Thanks again,

Didn't realise I posted in Omnigraffle - doh! I use that too, hence the mistake!

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Will OmniPlan for iPad open Microsoft Project files? amarsh OmniPlan for iPad 2 2012-06-07 10:41 AM
Exporting to Microsoft Project brendan OmniPlan Extras 3 2011-01-24 07:31 AM
Problem with export to Microsoft Project Last Exit OmniPlan Extras 2 2009-11-06 06:34 AM
Microsoft Project XML format import korm OmniPlan General 1 2008-09-18 03:52 PM
Microsoft XML Export Fails to Load in MS Proj 2003 HeelToe OmniPlan General 8 2007-01-05 03:14 PM

All times are GMT -8. The time now is 02:43 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.