Good morning.
I'm using OGP 5.11 and am having quite an issue entering text into a table.
I've created a 5 column x 11 row table and want to put text in these cells. What I'm missing is how to get the text in a table cell rather than on the page.
I can enter the needed text, but when I moved the table, the text stayed right where it was which indicates to me that while the text "appeared" in the cell, it wasn't actually "in" the cell.
With the text tool selected and hovering over a cell, I get flashing blue guide lines, yet when I left click to start typing, the ENTIRE table gets selected.
This can't be so hard, so I'll admit it's early and I may need more coffee, but for the life of me, I can't figure out what step I'm missing.
I've searched the forums and read the help file and didn't see any instructions on how to actually place text in a cell.
All help is appreciated
I'm using OGP 5.11 and am having quite an issue entering text into a table.
I've created a 5 column x 11 row table and want to put text in these cells. What I'm missing is how to get the text in a table cell rather than on the page.
I can enter the needed text, but when I moved the table, the text stayed right where it was which indicates to me that while the text "appeared" in the cell, it wasn't actually "in" the cell.
With the text tool selected and hovering over a cell, I get flashing blue guide lines, yet when I left click to start typing, the ENTIRE table gets selected.
This can't be so hard, so I'll admit it's early and I may need more coffee, but for the life of me, I can't figure out what step I'm missing.
I've searched the forums and read the help file and didn't see any instructions on how to actually place text in a cell.
All help is appreciated
Threaded Mode