The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Not quite getting orthogonal lines... Thread Tools Search this Thread Display Modes
Hi,
These seem to work fairly slick much of the time, but I'm also stumped by some behavior:
If I have an orthogonal lines (as shown in the attachment) and I move the lower horizontal segment up/down, it ALSO moves the other upper one. I want to move them *independently*, so I can put the orthogonal angles where I want them.

Check the forum and manual, so maybe there's something about this I'm not understanding...?

Thanks,
brian
Attached Thumbnails
Click image for larger version

Name:	Screen Shot 2013-05-21 at 12.14.18 AM.png
Views:	202
Size:	6.3 KB
ID:	2846  
 
Any ideas here? Seems I'm missing something pretty basic...
 
Hi bheller! Try double-clicking on the segment below to add a point. Then select that point and drag it around. Hope that helps!
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes



All times are GMT -8. The time now is 03:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.