The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
How to design an aggregation line (with the diamond) in UML notation? Thread Tools Search this Thread Display Modes
I've been trying to design an aggregation line (in UML notation) with the diamond at one end of the line. I've been using a square that I rotated 45 degrees and combined with a horizontal line. When I place that shape and tilt the line itself, the square doesn't follow the inclination of the line, it stays at it's 45 degrees setting. But it should rotate with the line...

I would appreciate your help in solving this. Thanks in advance
 
Why not just use the diamond line ending found in the Lines & Shape Inspector?
__________________
"Vroom! Vroom!!"
 
Hi Joel

Thanks for your suggestion. I wasn't aware of this possibility :)

BTW. The reason, why I reply so late to your post, is that I had been expecting an email notfication when someone replied to my post. But I never got any. I just found your reply because I decided to check the forum directly.
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Diamond in menu bar jsturtridge OmniOutliner 3 for Mac 4 2009-01-30 12:29 AM
Systems Biology Graphical Notation ronpar OmniGraffle General 0 2008-08-27 06:38 PM


All times are GMT -8. The time now is 09:33 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.