Hi All, I use stencils for doing sound system flows. I just upgraded to Omnigraffle 5.5 from version 5, and have found that tabbing through fields to enter text has changed.
It used to be that I would only be able to tab through one stencil's fields at a time, which is what I like. On the picture I'm linking you can see the fan out on the left side containing "Main L, Main R" etc. Ideally I like to be able to put all of my "devices" in the drawing, populate the fields with text, and then connect it all.
What seems to be happening in 5.5 is that the tab key will now tab through the fields on ALL stencils in the current drawing.
Is there a setting to change this behavior? It's SERIOUSLY slowing down my workflow on many projects.
Thanks all!
http://www.soundsneu.com/dropbox/public/omniexample.jpg
It used to be that I would only be able to tab through one stencil's fields at a time, which is what I like. On the picture I'm linking you can see the fan out on the left side containing "Main L, Main R" etc. Ideally I like to be able to put all of my "devices" in the drawing, populate the fields with text, and then connect it all.
What seems to be happening in 5.5 is that the tab key will now tab through the fields on ALL stencils in the current drawing.
Is there a setting to change this behavior? It's SERIOUSLY slowing down my workflow on many projects.
Thanks all!
http://www.soundsneu.com/dropbox/public/omniexample.jpg
Linear Mode
