The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniPlan > OmniPlan General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Mouse editing disabled in RC1? Thread Tools Search this Thread Display Modes
In OP RC1, I cannot edit any of the bars in GANTT chart with the mouse, as I cannot edit values in the outline section. I can edit the values in the inspectors, though. Essentially, it looks like my formerly generated document (in the betas) is now read-only, except for edits in the inspectors.

Any ideas?
 
Oh well,

1. loaded document. RC1 unlicensed => read-only.
2. licensed OP with RC1 key => document stayed read-only (at least, partially).

Closing and re-opening it after entering the license made it editable again.

Probably it's more a bug that I could edit it with the inspectors in read-only state, which should probably not be possible if the document was loaded as read-only (and shows so in the document window's title bar).

Anyway, problem solved.

-Christian
 
Did the plan you were editing have more than 20 tasks? Without a license, you cannot edit a plan with more than 20 tasks. Plans with fewer than 20 tasks should work fine.

Which fields were you able to edit in the inspectors when the document was in a read-only state?

Michelle
OmniQA
 
The plan had more than 20 tasks.

I was able to edit the actual end time and date of single tasks in Task:Information (didn't try any others).

-Christian
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Renaming and exit editing without mouse Tim1 OmniFocus 1 for Mac 3 2013-03-12 08:11 AM
disabled images not working Drayon OmniWeb Bug Reports 4 2012-02-07 12:28 AM
Preferences disabled?! -aleks- OmniFocus 1 for Mac 7 2008-08-18 12:35 PM
In line PDF viewing disabled? Drayon OmniWeb General 7 2007-07-18 04:31 PM
Seem to have disabled magnets? gobbles OmniGraffle General 2 2006-06-11 03:46 PM


All times are GMT -8. The time now is 10:17 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.