 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
| FAQ | Members List | Calendar | Today's Posts | Search |
| Visio Stencils | Thread Tools | Search this Thread | Display Modes |
|
Member
2007-12-05, 07:56 AM
Is there a way to import Visio Stencils into OmniGraffle?
Post 1
|
|
Member
2007-12-05, 08:21 AM
I guess I found my own answer...http://forums.omnigroup.com/showthread.php?t=1806
Still, you'd think this facility would be part of OmniGraffle at some point. I'd have to run both Windows and Visio to do this. Why use OmniGraffle then?
Post 2
|
|
Omni
2007-12-05, 09:35 AM
Now that OmniGraffle 5 (currently in beta) supports the Visio binary format, you should be able to open Visio stencils directly.
Post 3
|
|
Member
2007-12-10, 03:11 AM
Well, when I try to import Visio stencils, none works. Either I get the complaint that it uses a Windows-specific format called EML, or I get a "Out-of-bounds" error.
Any other tips? :-)
Post 4
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Converting Visio stencils to OmniGraffle | GregD-VisioCafe | OmniGraffle General | 11 | 2013-12-31 01:06 PM |
| Some questions about the Cisco stencils for Visio | Joel | OmniGraffle Extras | 10 | 2013-07-26 11:46 PM |
| Saving error message when using Visio stencils | oblomow | OmniGraffle Extras | 2 | 2008-06-20 12:45 PM |
| convert Visio stencils to Images | eagleman | OmniGraffle Extras | 3 | 2008-06-20 05:41 AM |
Linear Mode
