I'm having trouble getting some canvases to print correctly.
Cavas 1 in the file prints correctly on 8 1/2 by 11 paper. Canvas 2 prints the drawings, but super tiny, and in the upper right corner (a bit bleeds off the right and top of the paper's edge). I've reproduced this on 2 Lexmark printers.
However, if I export as an image or PDF, then print from those exports, the canvas prints fine. (Except there's too much white space at the top and bottom, but I'll take that for now.)
What I've noticed is that the "location" of the bad canvases on the gray working background is super close to the left and/or top edge. Meanwhile the good canvas appears in the middle of its gray working background. I don't know how to move the canvases, or if that's even possible.
Any ideas what is causing this? I've attached the file.
Cavas 1 in the file prints correctly on 8 1/2 by 11 paper. Canvas 2 prints the drawings, but super tiny, and in the upper right corner (a bit bleeds off the right and top of the paper's edge). I've reproduced this on 2 Lexmark printers.
However, if I export as an image or PDF, then print from those exports, the canvas prints fine. (Except there's too much white space at the top and bottom, but I'll take that for now.)
What I've noticed is that the "location" of the bad canvases on the gray working background is super close to the left and/or top edge. Meanwhile the good canvas appears in the middle of its gray working background. I don't know how to move the canvases, or if that's even possible.
Any ideas what is causing this? I've attached the file.