The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Line tool and rotations Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Sometimes when I draw a line with the line tool, the Geometry Inspector shows that the line is at a funny angle (310.6 degrees right now) even though the line is horizontal. Where's this setting coming from, and how can I reset it so that horizontal lines are at an angle of 0 degrees (or some other sensible value)?
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Timeline tool dfclark OmniGraffle Extras 14 2013-03-22 11:28 AM
Odd behavior - line tool rearrances shapes? [A: template with auto-layout enabled was chosen] erickhill OmniPlan General 2 2012-06-27 02:02 PM
Crop tool MatthewS OmniGraffle General 1 2012-06-21 07:17 AM
Round line ends not centered on end of line billbrietstout OmniGraffle General 3 2012-05-17 08:08 AM
Is OmniPlan the tool I need? sriggins OmniPlan General 2 2007-10-08 03:29 PM


All times are GMT -8. The time now is 11:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.