Hello,
I'm scratching my head trying to create a line terminating at another line (like a "T"), but with an intersect that looks like a round dot with the intersecting line going through the center. The closest I can come up with is a round line ending for the terminating line, but the round part is not intersected by the crossing line. I suppose I could add a round block object, but I just had to check first....so far my forum searches are fruitless.
Hopefully the picture will make sense, I'm not sure my words do!
Thanks!
Terry
ps: I'm using Pro v.4.1.2
I'm scratching my head trying to create a line terminating at another line (like a "T"), but with an intersect that looks like a round dot with the intersecting line going through the center. The closest I can come up with is a round line ending for the terminating line, but the round part is not intersected by the crossing line. I suppose I could add a round block object, but I just had to check first....so far my forum searches are fruitless.
Hopefully the picture will make sense, I'm not sure my words do!
Thanks!
Terry
ps: I'm using Pro v.4.1.2
Linear Mode
