The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
How to stop a line snapping to object in Omnigraffle? Thread Tools Search this Thread Display Modes
I have battled with this for hours, googled my head off and can't find the answer. I just want to draw a line from one place to another, and not have it snap to a connector point on an object. Then I want to rotate it.
 
Try holding down the option key while drawing the line.
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
How to stop a line snapping to object in Omnigraffle? lukesawyer OmniGraffle General 3 2011-12-22 08:13 AM
Stretching and snapping to object edge jmca OmniGraffle General 0 2011-12-06 05:36 AM
Can't detach a line from an object countdrachma OmniGraffle General 2 2011-08-16 07:21 PM
How to stop a line snapping to object in Omnigraffle? ardyayaf OmniGraffle General 2 2011-03-02 08:47 AM
How to turn off line "snapping"? technica OmniGraffle General 4 2008-01-29 05:14 PM


All times are GMT -8. The time now is 12:48 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.